Top-Entry and Back-Entry Urinals: Connections and Installation Explained
Understand urinal flush inlets, exposed and concealed pipework, service access and the measurements that matter when replacing a bowl.
Basterfield EngineeringUpdated
What top entry and back entry mean
Top entry and back entry describe where flushing water enters the urinal bowl. A top-entry connection receives the flush at the top; a back-entry connection receives it from behind. They describe a water connection, rather than the waste outlet or the way the bowl is fixed to the wall.
This distinction matters because the bowl, flush pipe and control must form a compatible arrangement. Two bowls can look similar from the front while requiring different pipe routes. Understanding the connection first makes it easier to read a drawing and assess whether an existing installation can be reused.
Follow the water route from control to bowl
An exposed arrangement leaves the control and connecting pipe accessible on the room side. A concealed arrangement takes the connection behind the finished wall or into a service space. The Basterfield B17744 range provides a useful example: B17744(T) has a top-entry inlet for an exposed connection, while B17744(B) has a back-entry inlet for concealed pipework.
Think of the route as a continuous line from the supply through the flush control and pipe to the bowl coupling. Each change of direction, connection position and component must suit that route. An inlet direction alone does not prove that a particular valve or pipe fits.
Appearance is only part of the decision. Exposed components may be easier to inspect from the room, while concealed components require a planned way to reach them. A finished wall should not leave a replaceable control or connection inaccessible.
The flush inlet and waste connection are separate
The flush inlet brings water in; the waste connection takes the discharge away. They need to be checked independently. Moving a supply connection does not resolve an incorrectly positioned drain.
The B17744 bowl has a 40 mm waste opening. That dimension describes the bowl aperture; it does not establish that a waste fitting or trap is included. The selected waste assembly, trap and connection to the building drainage need their own checks. On a replacement job, record the waste position and available clearance beneath or behind the bowl as carefully as the flush connection.
How the B17744 components work together
Both B17744 inlet versions have a Grade 304 stainless steel bowl, integral mounting brackets, a brass flush coupling and a flush spreader. The bowl and flushing accessories are separately specified and priced.
For the back-entry bowl, the listed optional control is B17744(155UW), a concealed 15 mm push-button flush system. For the top-entry bowl, the listed arrangement uses one Walcro 103LUR lever-operated valve and one UR15TP offset flush pipe per bowl. The pipe is part of that arrangement and should not disappear from the component schedule.
These are examples of matched catalogue components. They do not establish that the building supply is suitable or that the same combination applies to a different urinal family. The selected valve's operating requirements must be checked against the actual supply.
Survey a replacement before removing the old bowl
A useful replacement survey connects photographs to measurements. Take a front view that shows the complete installation and a side view that shows the distance from the wall. Mark where each dimension starts, such as finished floor level or the finished wall face.
Record the flush inlet centre, waste centre, mounting positions and access to the existing control. Note wall finishes and any service opening. A photograph without a scale can reveal the general arrangement but cannot establish that a new bowl will align with old pipes.
Check wall support as well as hole positions. Integral brackets describe the bowl's mounting provision; the wall construction and suitable fixings still have to be assessed for the installation. Record anything that cannot be confirmed until the existing fixture is removed.
Plan for servicing after the room is finished
Imagine replacing the valve or a connection after the installation is complete. Can the relevant part be isolated, reached and removed? Will a cubicle divider, cladding panel or adjacent fixture obstruct that work? The answer should be visible in the layout, rather than left to the maintenance team later.
A clear record of the bowl model, inlet arrangement and separate accessories also makes future parts identification easier. Keep that record with the installation drawing so a later replacement starts with evidence of the installed arrangement.